Go Back   Indiana Truck Scene Forum > Search Forums
Reload this Page Search Results
Become a Supporting Member         Become a Preferred Vendor

Showing results 1 to 10 of 10
Search took 0.00 seconds. Search: Posts Made By: Devs93
Forum: Engine Performance 10-31-2012, 09:28 AM
Replies: 9
Views: 16,233
Posted By Devs93
Do you need one and which one? Well, in most...

Do you need one and which one? Well, in most cases, no. But there are times where a limited-slip or mechanical locking differential is extremely useful, especially in a truck. Winter traction is a...
Forum: Engine Performance 10-31-2012, 09:28 AM
Replies: 9
Views: 16,233
Posted By Devs93
What are some ways to improve automatic...

What are some ways to improve automatic transmission performance?
There are two commonly found 4-speed automatic transmissions: 4L60/700R4 or 4L60E. GM rated these transmissions up to 370 lbs-ft of...
Forum: Engine Performance 10-31-2012, 09:27 AM
Replies: 9
Views: 16,233
Posted By Devs93
I like the 454SS, but I have a small block in my...

I like the 454SS, but I have a small block in my truck. Would you recommend a 454 engine swap in place of my engine?
Well, any engine swap is possible. There is no doubt the 454 engine is super cool...
Forum: Engine Performance 10-31-2012, 09:27 AM
Replies: 9
Views: 16,233
Posted By Devs93
Are there any aftermarket y-pipes available that...

Are there any aftermarket y-pipes available that are mandrel bent?
Yes, Edelbrock makes them and they are 2 1/2” down pipes into a 3” intermediate pipe. It is sold as an off-road unit, but it would...
Forum: Engine Performance 10-31-2012, 09:26 AM
Replies: 9
Views: 16,233
Posted By Devs93
So to answer the question - is it worth it? On a...

So to answer the question - is it worth it? On a mostly stock engine with stock heads - no. Even on a performance motor, I'm not sure if the added expense justifies the minimal performance gains...
Forum: Engine Performance 10-31-2012, 09:26 AM
Replies: 9
Views: 16,233
Posted By Devs93
Can I install a hydraulic roller camshaft in my...

Can I install a hydraulic roller camshaft in my TBI engine? What do I need to know?
Yes, the TBI engine blocks have all the provisions for hydraulic rollers, including the bosses for the spider....
Forum: Engine Performance 10-31-2012, 09:25 AM
Replies: 9
Views: 16,233
Posted By Devs93
Heads: The Vortec heads are great heads, but...

Heads: The Vortec heads are great heads, but there are not without their problems. The valve springs only support up to 0.450-0.470” lift camshafts depending on the sources you read. Since the Vortec...
Forum: Engine Performance 10-31-2012, 09:25 AM
Replies: 9
Views: 16,233
Posted By Devs93
What is an adjustable fuel pressure regulator,...

What is an adjustable fuel pressure regulator, who makes them, and are they worth it?
A fuel pressure regulator does just as it sounds. It limits the amount of fuel that enters into your injector...
Forum: Engine Performance 10-31-2012, 09:25 AM
Replies: 9
Views: 16,233
Posted By Devs93
How do I adjust my TPS? On TBI engines, the TPS...

How do I adjust my TPS?
On TBI engines, the TPS is not adjustable. Just leave it alone. You can test it for proper operation using a volt meter, but there is no need to adjust it. Here’s a link that...
Forum: Engine Performance 10-31-2012, 09:25 AM
Replies: 9
Views: 16,233
Posted By Devs93
The Ultimate 88/98 Toolbox

Copied and pasted this from another site tons of awsome info
I’ve been on the forum long enough to notice the same questions popping up again and again. Although the forum has a search feature, it...
Showing results 1 to 10 of 10

 
Forum Jump
Vendors
Sponsors